How To Repair Sunroof Leaks Outback
Sunroof leak repair
Sunroof leak repair — DIY fix for sunroof leaks
Most sunroofs leak
But carmakers anticipate that and install gutters and drains direct under the sunroof seals so the water can drain out without dissentious your vehicle. Sunroofs have at least ii drains in the front end corners and i or two drains in the rear.
Most common cause of sunroof leaks — clogged drain tubes
Leaves and organic matter that gets caught in the tracks will wind upward clogging the sunroof drains. When that happens, water volition leak into your vehicle.
Avoid this mistake when trying to clean sunroof drains
DIY's oftentimes attempt to snake the sunroof drain using a glaze hanger. DO Non Exercise THIS! The sunroof drains are made from prophylactic tubing and a glaze hanger will puncture the drain line, causing a worse leak. To supersede the line you'll accept to drop the headliner and run a new drain line.
Sunroof leak repair technique
Almost of the clogs are located right at the pinnacle of the drain tube, and so it makes more sensor to VACUUM out the clog than to try and push it all the way down the front or rear colonnade. Unfortunately, these drains are pocket-size and many times your household vacuum cleaner hose can't get in deep plenty to create the suction you need. And so make this simple adapter using PCV parts from any hardware or dwelling house center store. Then apply your vacuum cleaner to suck the debris out of the drain tubes.
If that doesn't work, and the clog is farther downward the drain, buy a speedometer cable from any auto parts shop. Insert the flexible cable into the tube and twist it as it goes downward. That volition break upwards the clog. So you can suck the droppings out with your sunroof drain tool.
Sunroof leak repair tool
To make the vacuum hose adapter you'll need the post-obit items:
• 1-1/four″ x 1-1/2″ male person PVC trap adapter
• ane-i/2″ PVC cap
• three/8″ MIP (threaded) ten barbed adapter
• 3/8 I.D. vinyl hose
• If y'all plan to use a shop vacuum with a 2-i/2″ hose, purchase a 2-1/2″ 10 i-one/4″ reducer.
I used PVC primer and mucilage to permanently glue the cap to the trap adapter. Then I drilled a hole in the heart of the cap and screwed in the 3/8″ barbed adapter. Adhere the vinyl hose the spinous cease of the adapter. If you're using a shop vacuum with a 2-1/2″ hose, only add together on a reducer. Insert the vacuum hose into the trap adapter and tighten the nut. Then vacuum out the clog.
©, 2022 Rick Muscoplat
Posted on past Rick Muscoplat
Source: https://ricksfreeautorepairadvice.com/sunroof-leak-repair/
Posted by: larsenvalinarts.blogspot.com
0 Response to "How To Repair Sunroof Leaks Outback"
Post a Comment